Using Purifico is as easy as 1-2-3
What you need for
hair and body wash
Step 1: Lock it in.
Detach the Base from the Watertight Cover.
Insert tube into base.
Place Watertight Cover over the Refill Cardboard Tube and firmly re-attach to the Base.
Step 2: Shake it out.
Give the Infinity Dispenser a few good shakes.
Hold your hand underneath the bottom and press the button on the Base.
A pod should pop right out.
Close the base door tightly again so no water gets in and dissolves pods.
(if pod does not pop out, just close the door and shake again)
Step 3: Suds it up.
Let water pool in your hand over the pod.
Biodegradable film will dissolve (rise away) in 5-7 seconds.
Rub your hands together to create a rich, sudsy lather.
Rinse completely when done.
Sometimes pods will release the liquid before they fully dissolve. If that happens you can let the small piece of residual film rinse down the drain. The film will fully dissolve and will not damage your skin, hair or plumbing.
*What if:
What if no pods come out?
Close the Base and shake it again.
What if two pods come out?
Consider yourself extra clean :) Don’t try putting the second one back in the dispenser – you’ll risk getting water inside and melting the other pods.
If you find that two pods are coming out often, try shaking out a little less vigorously. And make sure that the Base is fully shut before shaking.
Tip:
1. Always close the Base before setting your Infinity Dispenser down. Make sure it’s fully closed so no water gets in the dispenser, or your pods.
2. Always keep the dispenser base-side down. Especially in the shower. You don’t want water to get inside the dispenser because you’ll risk melting the pods.
And no one likes a melted pod :)